Removing and installing radio (MMI)

Make

Audi

Model

A1

Section

Infotainment › MMI infotainment system › Removing and installing radio (MMI)

Vehicle electricsRemoving and installing radio (MMI)

Removing and installing radio (MMI) The radio -R- is located in the luggage compartment (left-side) beneath the luggage compartment floor. Special tools and workshop equipment required

t  Radio release tool -T10057-

t  Protective cap for cable connector -VAS 6223/9- –  When renewing control unit, select „Replacement“ function for appropriate control unit in „Guided Fault Finding“. Use → Vehicle diagnostic tester to do so. –  Switch off ignition and all electrical equipment and remove ignition key. Removing –  Take out luggage compartment floor. –  Detach cover on control unit bracket. First remove control unit bracket. –  Remove the digital sound package control unit -J525- → Chapter. Electrical connectors remain attached. –  Release and unplug all connectors at radio -R-.

–  Fit protective cap for cable connector -VAS 6223/9--1- onto MOST bus connector -2-.

–  Unscrew nuts -2- at bracket -1-. –  Swivel bracket -1- into luggage compartment until front side of radio -R- is accessible.

–  Insert two radio release tools -T10057- into slots on radio -R--1- until they engage. Pointed ends of grips must face outwards. –  Grasp hold of grips on radio release tools -T10057- and pull radio -R--1- out of bracket. –  Press release tabs on radio -R- and remove radio release tools -T10057-. Installing –  Install in reverse sequence of removal. Tightening torques → Chapter

05 General