Audi Workshop Service and Repair Manuals > A3 Mk2 > Power transmission | 6-speed manual gearbox 02Q, four-wheel drive | Clutch, control | Exploded view - pedal cluster, clutch master cylinder | Removing and installing clutch position sender G476

Removing and installing clutch position senderG476

Removing and installing clutch position sender -G476-

Removing

Vehicles with TFSI engine (with timing chain), TDI engine or V6 engine:

–	Remove air cleaner housing completely → Rep. Gr.23 or → Rep. Gr.24.

Vehicles with TFSI engine or TDI engine:

Caution

When disconnecting the battery there is a risk of serious damage to electronic components:

Observe the correct procedure for disconnecting the battery.

–	Remove battery → Electrical system; Rep. Gr.27.

–	Remove battery tray -arrows- (detach front of battery tray from air duct if applicable).

Continued for all vehicles:

–	Unplug electrical connector -4-, and unclip and detach clutch position sender -G476- from master cylinder -arrow-.

Note

-Items 1, 2 and 3- can be disregarded.

Installing

Installation is carried out in reverse sequence; note the following:

–	Install battery tray and battery → Electrical system; Rep. Gr.27.

–	Install air cleaner housing → Rep. Gr.23 or → Rep. Gr.24.

Audi Workshop Service and Repair Manuals