Audi Workshop Service and Repair Manuals

Servicing clutch housing

Special tools and workshop equipment required

t	Press tool -VW 407-

t	Sleeve -30 - 21-

t	Drift -T10168-

t	Thrust piece -T40008-

t	-1- Kukko internal puller 21/2 and 21/4

t	-4- Kukko counter-support 22/1 and 22/2

Pulling out bearing bush for selector rod A -  Counter-support, e.g. -Kukko 22/1- B -  Internal puller 14.5 ... 18.5 mm, e.g. -Kukko 21/2-

Driving in selector rod bush –  Drive in bush until tool contacts stop.

Pulling needle bearing out of clutch housing A -  Counter-support, e.g. -Kukko 22/2- B -  Internal puller 23.5 ... 30 mm, e.g. -Kukko 21/4-   Note The needle bearing is destroyed during removal and must be renewed.

Pressing needle bearing into clutch housing –  Before pressing in, place reverse shaft thrust washer -B- on needle bearing -A-.

Pressing reverse gear selector fork shaft into clutch housing