A3 Mk2
Exploded view - dismantling and assembling Haldex coupling (generation „Haldex II“), rear final drive „02D/0AV“ |
1 - | Multi-plate clutch |
q | Overview → Fig. „„Assembly of multi-plate clutch““ |
q | Removing and installing → Chapter |
2 - | Bolts |
q | 6 Nm |
3 - | Haldex coupling pump -V181- |
q | Removing and installing → Chapter |
4 - | O-ring |
q | Diameter 32 mm |
q | For Haldex coupling pump -V181- |
q | Lubricate lightly with high-performance oil for Haldex coupling before fitting |
q | Always renew |
5 - | O-ring |
q | Diameter 30 mm |
q | For Haldex coupling pump -V181- |
q | Lubricate lightly with high-performance oil for Haldex coupling before fitting |
q | Always renew |
6 - | Sealing cap |
q | 35 Nm |
7 - | O-ring |
q | For sealing cap |
q | Lubricate lightly with high-performance oil for Haldex coupling before fitting |
q | Always renew |
8 - | Oil filter bracket |
9 - | O-ring |
q | For oil filter bracket |
q | Lubricate lightly with high-performance oil for Haldex coupling before fitting |
q | Always renew |
10 - | O-ring |
q | For oil filter |
q | Lubricate lightly with high-performance oil for Haldex coupling before fitting |
q | Always renew |
11 - | Oil filter |
q | For Haldex coupling |
q | No change required |
q | Removing and installing → Chapter |
12 - | Spring |
13 - | Housing for Haldex coupling |
q | Removing and installing complete Haldex coupling → Chapter |
q | Detaching from multi-plate clutch → Chapter |
14 - | Nut |
q | 210 Nm |
q | Apply locking fluid -D 000 600- when fitting |
15 - | Flange for propshaft |
q | Removing and installing → Chapter |
16 - | Oil seal for propshaft flange |
Renewing → Chapter |
17 - | Circlip |
18 - | Ball bearing |
q | Removing and installing → Chapter |
19 - | Four-wheel drive control unit -J492- |
q | With coupling opening control valve -N373- |
q | With oil pressure and oil temperature sender -G437- |
q | Removing and installing → Chapter |
20 - | Bolts |
q | 6 Nm |
21 - | O-ring |
q | Lubricate lightly with high-performance oil for Haldex coupling before fitting |
q | Always renew |