Assembly overview: Brake pedal, LHD models

Make

Audi

Model

A4 Mk1

Section

Brake system › Brake, brake mechanics › Assembly overview: Brake pedal, LHD models

Running gearAssembly overview: Brake pedal, LHD models

Assembly overview: Brake pedal, LHD models Assembly overview: Brake pedal, LHD models

Important The brake pedal travel must not be shortened by additional floor coverings. Bracket ◆ Removing and installing Cheese head bolts, 5 Nm ◆ Must engage in recess of pin (Item12). ◆ Do not tighten bolt until circlips (Item 13) have been fitted. Seal Cheese head bolts, 20 Nm Master cylinder Torsion spring ◆ Differs on 4- and 6-cylinder engines

Clutch pedal ◆ Located in position by clutch master cylinder adjustment ◆ Push on to pin, Item 12 Pin ◆ Insert in clutch pedal and master cylinder ◆ Lock pin in pedal -arrow-. Brake pedal ◆ Fit onto pin Accelerator ◆ Clip into pedal bracket

Accelerator cable ◆ Detent ball of the accelerator cable should be locked in accelerator cable mount of accelerator pedal. Pin Circlip (2*) ◆ Always replace ◆ Fit onto pin Cable pulley with linkage ◆ TDI only Hexagon nut, 8 Nm ◆ Always replace Washer Combi bolt, 25 Nm ◆ Tighten in vehicle after brake servo unit has been installed

Vent valve for cruise control system ◆ Adjusting => Page 46-110 Brake light switch ◆ Adjusting => Page 45-45 ◆ Adjusting at spring clip Clip/spring clip ◆ Always replace ◆ Insert in mounting bracket ◆ Press spring clip into pedal bracket from rear => Page 45-45 Stop buffer ◆ Observe marking: ◆ Manual gearbox position: HS inscription is visible and AG inscription points in direction of travel ◆ Automatic gearbox position: AG inscription is visible and HS inscription points in direction of travel

Dash panel crossmember Jointing pin ◆ Fit pedal bracket onto jointing pin Pedal position sensor ◆ TDI only Cheese-head bolt, 8 Nm

01 Steering & suspension