Audi Workshop Service and Repair Manuals

• 25 Nm
• ◆ Replace
• Gasket
• ◆ Replace
• 25 Nm
• 25 Nm
• ◆ Replace
• Turbocharger
• Gasket
• ◆ Replace

• Catalytic converter
• ◆ With decoupling element
• ◆ To avoid damage, do not bend decoupling element by more than 10°
• ◆ Protect against jolts and impact
• ◆ Removing and installing=>Page 26-19
• 40 Nm
• Front clamp
• ◆ Before tightening, perform stress-free alignment of exhaust system
  => Page 26-23
• ◆ Installation position: Bolted joint pointing to right
• ◆ Installation position of bolt ends
  => Fig.26-13
• ◆ Tighten bolted joints evenly

• Front silencer
• ◆ Combined with rear silencer as original equipment; replace separately when performing repair work
• ◆ Cutting point => Page 26-16
• ◆ Stress-free alignment of exhaust system => Page 26-23
• Rear clamp
• ◆ For separate replacement of front and rear silencer-
• ◆ Before tightening, perform stress-free alignment of exhaust system
  => Page 26-23
• ◆ Installation position: Bolted joint pointing to left
• ◆ Installation position => Fig.26-13
• ◆ Tighten bolted joints evenly

• 25 Nm
• Mounting
• Rear silencer
• ◆ Combined with front silencer as original equipment; replace separately when performing repair work
• ◆ Cutting point => Page 26-16
• ◆ Stress-free alignment of exhaust system => Page 26-23
• Mounting
• 25 Nm
• 25 Nm
• Mounting
• 40 Nm

• Mounting
• 25 Nm
• Exhaust pipe
• ◆ Removing and installing=>Page 26-19

→ Fig.1    Installation position of front clamp

• ‒ Fit clamp such that it is horizontal.
• ‒ Bolted joint faces right

→ Fig.2    Installation position of rear clamp

• ‒ Fit clamp such that it is horizontal.
• ‒ Bolted joint on left