Audi Workshop Service and Repair Manuals

Removing:

• ‒ Remove gearbox

=> 6-Speed manual gearbox 01E, four-wheel drive; Repair group 34; Removing and installing gearbox

• ‒ Remove clutch
• ‒ → With crankshaft at TDC, screw in clamping bolt 3242.
• ‒ Mark position of flywheel relative to engine
  -arrows-.
• ‒ Unscrew bolts (bolts must be renewed).

Note:

The needle bearing is located in the flywheel and must be pressed in if a new flywheel is installed .

Installing

• ‒ Install dual-mass flywheel.

Note:

Always renew flywheel securing bolts.

• ‒ → With crankshaft at TDC, unscrew clamping bolt 3242.
• ‒ Install clutch

=> 6-Speed manual gearbox 01E, four-wheel drive; Repair group 30; Servicing clutch

• ‒ Install gearbox

=> 6-Speed manual gearbox 01E, four-wheel drive; Repair group 34; Removing and installing gearbox