Dismantling and assembling selector mechanism

Make

Audi

Model

A4 Mk2

Section

Automatic gearbox, control, assembly, housing › Exploded view - selector mechanism › Dismantling and assembling selector mechanism

Power transmissionDismantling and assembling selector mechanism

Dismantling and assembling selector mechanism

  Note

t	Removing and installing securing spring for locking cable → Fig..

t	If selector gate or selector housing are defective the entire selector mechanism has to be renewed. The two components cannot be adjusted using workshop tools.

Dismantling –  Shift selector lever to position “S”. –  Remove selector lever lock solenoid -N110--item 7- → Chapter. –  Unbolt and then unclip selector gate -12- from selector housing -14-. –  Release pivot pins -5- and -19- and pull them out sideways. –  Unclip retainers -2- and -16-. –  Pull off retaining clip -17-. –  Swivel locking lever -11- upwards as far as it will go. –  Pull selector lever -6- together with bushes -3- and -15- and tiptronic locking levers -4- and -18- downwards out of selector housing -14-.

Assembling –  Make sure that selector lever is still in position “S”. –  Swivel locking lever -11- upwards as far as it will go. –  Insert selector lever -6- into selector housing -14- from below. –  Fit tiptronic locking levers -4- and -18- and bushes -3- and -15- onto selector lever. –  Push selector lever -6- together with bushes into selector lever housing -14- and position with retaining clip -17-. –  Engage retainers -2- and -16- on selector housing. –  Press pivot pins -5- and -19- into selector lever -6- until they engage. –  Check that the pivot pins are engaged in the tiptronic locking lever. –  Install selector lever lock solenoid -N110--item 7- → Chapter. –  Clip selector gate -12- onto selector housing -14- and tighten to 0.4 Nm.

Removing and installing securing spring for locking cable Removing –  To remove locking cable, lift spring slightly at the top -arrow B-. –  Disengage spring from retainer lug -arrow C- and lift out. Installing –  Insert spring from above -arrow B- and engage under retainer lug -arrow C-. –  Align spring so that it lies level in groove -arrow A-. –  To install locking cable, lift spring slightly at the top -arrow B-.

04 Transmission

The same page in: A4 Cabriolet Mk2.