audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Removing and installing control unit for electromechanical parking brake -J540- > < Removing and installing mounting bracket (vehicles with automatic gearbox)
Electronic parking brake (EPB) - overview
   
Electronic parking brake (EPB) - overview
1 - Parking brake contact switch -F321-
Switch is permanently lit for easy identification at night
q   Pull switch ⇒ to apply „handbrake “.
q   Press switch ⇒ to release brake; vehicle must then be held with footbrake
q   Fitting location: in centre console
q   Removing and installing → Chapter
2 - LED (light-emitting diode)
q   Fitting location: in parking brake switch
q   Lights up when parking brake is applied
q   Indicator lamp in instrument cluster as additional display
Indicator bar lights up red when vehicle is retarded by EPB at speeds above 7 km/h. The system also sounds an audible warning tone.
3 - EPB system fault warning lamp (yellow)
q   In case of malfunction of the parking brake the yellow symbol in the instrument cluster display lights up additionally and the warning: Parking brake! is displayed.
4 - Indicator lamp for electromechanical parking brake
Lamp lights up red:
q   To indicate that required clamping force has been built up
q   The lamp lights up with parking brake applied and ignition switched on.
q   The lamp stays on for approx. 20 seconds after the ignition is switched off.
q   If the parking brake is applied with ignition switched off, the lamp lights up for approx. 20 seconds.
q   The lamp should go out when the parking brake is released.
Lamp flashes red:
If the lamp flashes red continuously after the parking brake has been applied, this can have one of the following causes:
t  The braking force developed by the parking brake is not sufficient to prevent the vehicle from rolling
t  The temperature of the brakes is too high
If the lamp flashes red, the vehicle must be held by another means
Lamp lights up green:
q   Lamp indicates that Audi hold assist (AHA) is active
Yellow warning lamp lights up additionally:
q   In case of malfunction of the parking brake the yellow symbol in the instrument cluster display lights up additionally and the warning: Parking brake! is displayed.
5 - Actuator motor for electronic parking brake with brake caliper (right-side)
q   Removing and installing → Chapter
q   Detaching and attaching brake caliper → Chapter
6 - Control unit for electromechanical parking brake -J540-
q   Fitting location: in rear right side panel behind side trim
q   Removing and installing → Chapter
q   9 Nm
7 - Actuator motor for electronic parking brake with brake caliper (left-side)
q   Removing and installing → Chapter
q   Detaching and attaching brake caliper → Chapter
8 - Acoustic signal
q   Warning signal if parking brake is operated while road speed is above 7 km/h
q   Warning signal if a fault is detected in system

   

Removing and installing control unit for electromechanical parking brake -J540- > < Removing and installing mounting bracket (vehicles with automatic gearbox)