audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing front brake pads - FN-3 brakes > < Removing and installing front brake caliper with brake carrier - FN-3 brakes

A4 Mk3

Renewing front brake caliper - FN-3 brakes
Renewing front brake caliper - FN-3 brakes
Always use new bolts → ETKA.
Removing
Special tools and workshop equipment required
t  Torque wrench -V.A.G 1332-
t  Ratchet -V.A.G. 1332/1-
t  Torque wrench -V.A.G 1331-
t  Ratchet -V.A.G. 1331/1-
t  Brake pedal actuator -V.A.G 1869/2-
   
–  Insert brake pedal actuator -V.A.G 1869/2- between brake pedal and driver's seat (depress brake pedal at least 60 mm). This closes the valves in the brake master cylinder and stops the brake fluid reservoir from running empty.
–  Raise the vehicle.
–  Remove wheels.
–  Connect hose of bleeder bottle to bleeder screw of front brake caliper.
–  Open bleeder screw on front brake caliper to release pressure from brake system.
–  Close bleeder screw.
  Note
Do not remove brake pedal actuator -V.A.G 1869/2-.
–  Remove brake pads → Chapter.
  Note
t  Mark brake pads when removing them if they are to be reinstalled. Reinstall in their original position to prevent uneven braking.
t  The brake disc is secured with a bolt.
–  Disconnect brake hose from brake caliper.
–  Remove brake caliper from vehicle.
–  Remove bolts -5- on brake carrier, holding brake carrier firmly.
  A44-0020

–  Detach brake carrier.
Installing
Always use new bolts → ETKA.
–  Fit brake carrier.
–  Secure brake carrier with new bolts -5-.
   

–  Connect brake hose to caliper and tighten connection.
–  Install brake pads → Chapter.
  Note
After each brake pad change firmly depress brake pedal several times with vehicle stationary, so that the brake pads are properly seated in their normal operating position.
–  Remove brake pedal actuator -V.A.G 1869/2-.
–  Bleed brake system → Chapter.
–  Fit wheels.
Tightening torque for wheel bolts → Rep. gr.44
   

Removing and installing front brake pads - FN-3 brakes > < Removing and installing front brake caliper with brake carrier - FN-3 brakes