Q7 Quattro V6-3.6L (BHK) (2007)
-
Insert studs on lever of Defroster Flap Motor V107 - A - into guiding groove of lever on defroster flap - D -.
NOTE: Position - H - shows the respective adjustment range of the control motors.
Remove control motor on retaining plate.
-
Install the removed components again in reverse order.
-
Check DTC memory of front A/C control head Climatronic Control Module J255 and erase DTCs displayed if necessary. Vehicle Diagnosis,
Testing and Information System VAS 5051 in "Guided Fault Finding" function.
-
Perform basic setting (and output Diagnostic Test Mode (DTM) if necessary) on the A/C system. Vehicle Diagnosis, Testing and Information
System VAS 5051 in "Guided Fault Finding" function.
Defroster Flap Motor V107 - Instrument Panel Installed, Removing And Installing
Removing
-
Remove retaining plate - D - with Defroster Flap Motor V107, Left Side Vent Motor V299 (and Left Center Vent Motor V110).
-
Mark the control motors if necessary (versions vary Parts Catalog).
-
Remove bolts - E - from Defroster Flap Motor V107 - A -, remove motor.
NOTE: Left Center Vent Motor V110 - C - is present only on vehicles with a "Comfort" version A/C system.
Installing
Remove control motor on retaining plate.
-
Install retaining plate - D - with Defroster Flap Motor V107, Left Side Vent Motor V299 (and Left Center Vent Motor V110).
NOTE: Check the lever position of the control motors before installing retaining plate, the retaining plate can only be installed correctly when it
is located in the service position.
-
Install the removed components again in reverse order.
-
Check DTC memory of front A/C control head Climatronic Control Module J255 and erase DTCs displayed if necessary. Vehicle Diagnosis,
Testing and Information System VAS 5051 in "Guided Fault Finding" function.
-
Perform basic setting (and output Diagnostic Test Mode (DTM) if necessary) on the A/C system. Vehicle Diagnosis, Testing and Information
System VAS 5051 in "Guided Fault Finding" function.