5 Series E34 525td (M51) TOUR
Measure friction torque with special tool 00 2 000 and suitable
socket adapter,
refer to Technical Data.
Caution!
The relation between friction torque and preload force differs
depending on the make of bearings.
Refer to pinion bearing table for specified friction torque,
refer to Technical Data,
and add 20 Ncm for the new shaft seal.
Install final drive, install side cover after marking with the
appropriate washers (1) and install new O-rings (2). Tighten
screws down evenly.
Tightening Torque,
refer to Technical Data.
Backlash/tooth contact pattern adjustments
Secure special tool 00 2 500 (dial gauge holder) and measure
torsional face runout,
refer to Technical Data.
Caution!
The tooth contact pattern is always most important for a
perfectly adjusted pinion/crown wheel.
To check the tooth contact pattern, coat the crown wheel teeth
with printer's ink, turn in both directions several times and stop
crown wheel suddenly with a piece of hard wood.
RA Replacing bearing for input bevel gear (Type M) - final drive removed -
BMW AG - TIS
23.01.2013 07:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -
