CTS V6-3.2L VIN N (2003)
2. Connect the shift control rod (2) to the transmission and install the shift control rod pin (3).
3. Connect the reaction arm (4) to the transmission and install the reaction arm pin (5).
4. Install the shift control rod pin and reaction arm pin retaining clips (1).
5. Raise the rear of the transmission to the original position.
6. Install the transmission support.
7. Remove the transmission jack.
8. Install the propeller shaft coupler (1) to the transmission flange.
9. Install the exhaust system.
Notice: Refer to Fastener Notice in Service Precautions.
10. Install the bolts securing the shift control assembly to the shift control adaptor plate.
