SRX AWD V6-3.6L (2008)
Brake Fluid Pressure Sensor/Switch: Service and Repair
Brake Fluid Pressure Sensor Replacement
Removal Procedure
Important: The area around the electronic brake control module (EBCM) must be free from loose dirt to prevent contamination of
disassembled ABS components.
1. Thoroughly clean all contaminants from around the EBCM.
2. Disconnect the brake fluid pressure sensor electrical connector (3) from the brake fluid pressure sensor (2).
3. Remove the brake fluid pressure sensor (2) from the electronic brake control module (EBCM) (1).
Installation Procedure
