SRX AWD V6-3.6L (2008)
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
1. Install the brake fluid pressure sensor (2) to the EBCM (1).
Tighten the sensor to 17 N.m (13 lb ft).
2. Connect the brake fluid pressure sensor electrical connector (3) to the brake fluid pressure sensor (2).
3. Fill and bleed the hydraulic brake system. Refer to Master Cylinder Reservoir Filling (See: Hydraulic System/Brake Master Cylinder/Service and
Repair/Procedures/Master Cylinder Reservoir Filling) and to Hydraulic Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and
Repair)Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair) .
4. Perform the Auto Bleed Procedure. Refer to Antilock Brake System Automated Bleed Procedure (See: Brake Bleeding/Service and Repair) .
5. Perform the ABS Diagnostic System Check. Refer to Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and
Diagnostic Overview/Diagnostic System Check - Vehicle) .
