SRX AWD V6-3.6L (2008)
Important: Install the seal onto the tool before installing into the case to prevent damage to the seal.
1. Using J 44765 install the new transmission case extension seal (1).
2. Install a NEW output shaft assembly retainer (1). Position the retainer on end of the output shaft splines. The retainer will be pushed to the proper
depth as the drive flange is installed onto the output shaft.
3. Install a NEW drive flange O-ring seal (3) into the drive flange.
4. Install the drive flange (2) to the transmission output shaft.
5. Install a NEW drive flange thrust washer (4).
6. Install the J 45012 to the drive flange.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
7. While holding J 45012 Install a NEW drive flange nut using J 29873 .
Tighten the drive flange nut to 57 N.m (42 lb ft).
8. Remove J 45012 from the drive flange.
