SRX AWD V6-3.6L (2008)
9. Remove the mechanics wire (2) securing front propeller shaft (1) to the shift control lever (3).
10. Install the propeller shaft coupler (1) to the transmission flange. Refer to Rear Propeller Shaft Replacement (RWD) (See: Drive/Propeller Shafts,
Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Rear Propeller Shaft Replacement (RWD)) .
11. Install the exhaust system. Refer to Exhaust System Replacement (See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair) .
12. Place the transmission in the park position by rotating the shift shaft fully counter clockwise.
13. Connect the shift linkage to the transmission.
14. Install the transmission manual shift shaft nut.
Tighten the transmission manual shift shaft nut to 9 N.m (80 lb in).
15. Check the transmission fluid level. Refer to Transmission Fluid Check (See: Testing and Inspection/Component Tests and General
Diagnostics/5L40-E/5L50-E - Automatic Transmission/Transmission Fluid Check) .
16. Lower the vehicle.
Torque Converter Fluid Seal Replacement
Torque Converter Fluid Seal Replacement
Tools Required
*
J 8092 Universal Driver Handle
*
J 44766 Seal Installer
*
J 45000 Seal Remover
Removal Procedure
