Pacifica V6-3.8L VIN L (2005)
6. Assemble Remover 9050A as shown (Fig. 22).
NOTE: When installing thrust bearing on Remover, be sure to place hardened side toward nut.
7. Remove sleeve retaining spring link ball joint in knuckle as follows (Fig. 23):
a. Hand thread assembled Remover 9050A into tapped knuckle sleeve until it stops.
b. Rotate Nut down, matching Sleeve 905OA-5 angled end with angled face of knuckle.
c. Continue to rotate Nut until knuckle sleeve is removed from knuckle. Discard knuckle sleeve; replace it with new upon installation.