00 Introduction and technical data: Tightening torques (page 3 of 3)
- Make
- Fiat
- Model
- Bravo /Brava (182) Factory Service Manual
- Year
- 1995–2001
- Section
- Tightening torques
00 Introduction and technical dataTightening torques · page 3 of 3
| DESCRIPTION | Thread size | Tightening torques daNm |
ENGINE | |||||
|---|---|---|---|---|---|---|---|---|
| [1370] 12V |
[1591] 16V |
[1747] 16V |
[1958] 20V |
[1929] D |
[3110] TD |
|||
| Cover and bracket to water pump casing fixing, bolt | M8 | 2,3 | ✓ | |||||
| Water pump to cylinder head fixing, nut with flange | M8 | 2 | ● | ● | ● | ● | ||
| Oil pump drive shaft driven gear fixing, bolt | M10×1,25 | 8 | ● | |||||
| Thermostat to cylinder head fixing, nut | M8 | 2 | ● | ● | ● | ● | ● | ● |
| Driven gear to oil pump drive gear fixing, bolt | M10×1,25 left |
7 | ● | |||||
| Butterfly casing to inlet manifold fixing, bolt | M8 | 2,5 | ● | ● | ||||
| Ante-chamber fixing, ring nut | M32×1,5 | 11,8 | ● | ● | ||||
| Injection pump fixing, nut for stud | M8 | 2,5 | ● | |||||
| Injection pump fixing, bolt | M8 | 2,5 | ● | ● | ||||
| Flexible mounting to water pump casing fixing, nut | M12×1,25 | 8 | ● | |||||
| Injection pump drive gear fixing, nut | M12×1,25 | 4,9 | ● | |||||
| M14×1,5 | 5 | ● | ||||||
| Reaction bracket to oil filter support and injection pump fixing, bolt | M8 | 2,9 | ● | |||||
| Injection pump mounting to crankcase and inlet manifold fixing, bolt | M8 | 2,5 | ● | |||||
| Oil filter and injection pump mounting fixing, upper bolt or nut | M12×1,25 | 9,8 | ● | |||||
| Oil filter and injection pump mounting fixing, lower bolt | M10×1,25 | 7,1 | ● | |||||
| Complete injector | M24×2 | 5,5 | ● | ● | ||||
| Heater plugs | M12×1,25 | 1,5 | ● | ✓ | ||||
| Fuel supply pipe on injection pump and on injector, nuts | M12×1,25 | 2,9 | ● | |||||
Parts & tools for this job For 1995 Fiat Bravo
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.