Braking system
- Make
- Fiat
- Model
- Bravo /Brava (182) Factory Service Manual
- Year
- 1995–2001
- Section
- Tightening torques (98 range) › Braking system
00 Introduction and technical dataBraking system
| PART | Thread | Tightening torques daNm |
ENGINE | ||
|---|---|---|---|---|---|
| 1242 16v | 1998 20v STEP A |
1910 JTD | |||
| Tapered, thread | M22x1.5 | 4.6 | ● | ● | ● |
| Tapered threaded plug for filling gear case with oil | M22x1.5 | 4.6 | ● | ● | ● |
| Screw retaining differential right shaft support | M6 | 1 | ● | ● | ● |
| Tapered threaded plug for 1st-2nd speed rod seat on gear case | M18x1.5 | 2 | ● | ● | ● |
| Gear selection lever support retaining screw | M8 | 1.5 | ● | ● | ● |
| Reversing light switch | M14x1.25 | 3 | ● | ● | ● |
Braking system
| 1242 16v | 1998 20v STEP A | 1910 JTD | |||
|---|---|---|---|---|---|
| Screw with split safety washer retaining brake carrier plate to suspension arm | M8 | 2.4 | ● | ● | ● |
| Bolt retaining front brake caliper | M10x1.25 | 5.7 | ● | ● | ● |
| Bolt with tapered safety washer retaining front brake calipers to pillar | M12x1.25 | 10.5 | ● | ||
| Bolt retaining front brake disc, rear brake disc, rear brake drum (with wheel centring function) | M8 | 1.2 | ● | ● | ● |
| Bolt with tapered safety washer retaining bracket assembly for braking system | M8 | 2.5 | ● | ● | ● |
| Fitting connecting hose to front brake caliper | M10x1 | 1.4 | ● | ● | ● |
| Bleed screw on front and rear brake caliper | M8 | 0.6 | ● | ● | ● |
| Fitting connecting hose to rear brake caliper | M10x1 | 1.4 | ● | ||
| Bolt retaining cylinder to rear brake carrier plate | M6 | 0.8 | ● | ● | |
| Bleed screw on rear drum brake cylinder Ø180 | M8 | 0.65 | ● | ||
| Brake pump restriction fitting (ABS version) | M10 | 1.4 | ● | ● | ● |
Parts & tools for this job For 1995 Fiat Bravo
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.