LUCAS FT05 injection pump

Adjust toothed timing belt tension as follows: Fit part 1860745200 to tool 1860745100. Then position weight at a distance of 120 mm along the calibrated rod and secure. Apply the resulting tool to the mobile belt tensioner as shown in figure. Adjust joint to move calibrated rod to a horizontal position. Then tighten joint retaining screw. Settle the toothed belt by turning the crankshaft through two turns in the direction of rotation. Tighten mobile belt tensioner retaining screw. The calibrated rod may move away from the horizontal during the final stage. In this case, adjust joint again to restore calibrated rod to its original position and repeat the operation. Tighten mobile belt tensioner to the specified final torque.

LUCAS FT05 injection pump

1. Maximum rpm adjustment screw.
2. Anti-stall adjustment screw.
3. Fitting for adjusting pump timing on engine.
4. Fast idle adjustment screw.
5. Fast idle control lever.
6. Choke advance valve control rod.
7. Choke advance valve.
8. Engine stop solenoid protective cover.
9. Transfer pressure valve (*).
10. Fittings for diesel delivery lines to injectors.
11. Fitting for diesel return line from injectors.
12. Fitting for diesel return line to tank.
13. Accelerator control lever.
14. Fitting for diesel delivery line from filter.
15. Enrichment flow cut-out or supplement valve.
16. Automatic advance device.
17. Fiat CODE system interface ECU.

(*) This valve performs the following functions: a. Creates transfer pressure generated by vane pump. b. Controls transfer pressure on the basis of engine rpm c. Allows pump to fill with diesel during start-up (priming)