Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)02 · 10 Engine
02 · Engine

Removing-refitting cylinder head

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Removing-refitting cylinder head (1929 D) › Removing-refitting cylinder head
10 EngineRemoving-refitting cylinder head · page 1 of 4
Diagram showing the engine bay with arrows pointing to screws on the air intake shroud
Diagram of the air intake duct and resonator area with arrows indicating clips and a pipe connection

REMOVING-REFITTING CYLINDER HEAD

Before removing the cylinder head, remove the timing belt as described in the previous paragraph.

  1. Disconnect battery negative lead, then remove air intake shroud by undoing screws shown in figure.
  2. Disconnect air intake duct with resonator by undoing clips shown in figure and disconnecting pipe shown in box.
  3. Disconnect brake servo pipe from vane vacuum pump.
  4. Disconnect pipes shown in figure from radiator. First disconnect lower pipe in order to drain engine coolant.
  5. Disconnect coolant delivery pipe to radiator and coolant return line from heater.
Close-up diagram of a pipe connection with icons indicating upward and downward movement for disconnection
Diagram showing hoses connected to the radiator with clamps visible
Diagram showing coolant pipes connected to the thermostat housing and heater circuit

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.