Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)03 · 18 Clutch
03 · Transmission

Removing - refitting

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Clutch operation › Removing - refitting
18 ClutchRemoving - refitting
Diagram showing the thrust bearing sleeve location on the gearbox with arrows pointing to bolts

THRUST BEARING SLEEVE (only for 1581 - 1747 - 1998 - 1929 D versions)

NOTE The 1370 M.P.I. version is not fitted with a thrust bearing sleeve.

Removing - refitting

  1. Undo the bolts shown and remove the sleeve.

NOTE The seal is replaced each time leaks of gearbox oil are noticed. When re-fitting, smear the contact surfaces with silicon sealant which will act as a seal.

CLUTCH PEDAL

Photo showing the clutch pump assembly connected to the pedal mechanism under the dashboard
Photo showing the connection point of the clutch cable and pedal assembly
Small photo of a clip or retaining pin used in the clutch system
  1. Remove the clip fixing the clutch pump to the pedal (only for versions fitted with hydraulic mechanism - 1998 20v)

Removing-refitting clutch pedal

  1. Remove the clutch pedal acting at the point shown by the arrow and also disconnect the end of the clutch cable (value for all versions).
Icon indicating lubrication or grease application

the parts concerned before fitting.

F5 For the 1998 20v versions do not lubricate the rubber bush (Silent-block) connecting the pump - pedal as this will cause the material to deteriorate.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.