REMOVING-REFITTING HYDRAULICAL-LY OPERATED CLUTCH COMPONENTS (1998 20v)

1. Release the clutch cable from the anchorages (1) on the bodyshell as illustrated in the diagrams above at the side (for 1581 - 1747 - 1929 D versions only).
2. Lift up the carpet (1) near the clutch pedal.
   Disconnect the end (3) of the clutch cable from the pedal (2) (for all versions).
3. From inside the engine compartment, remove the flexible buffer from the anchorage hole in the dashboard bulkhead and extract the complete clutch cable (for all versions).

When refitting the clutch cable it is necessary to position the flexible rubber buffer (1) on the dashboard bulkhead and then insert the rigid buffer (2) in the opening in the flexible buffer. When the operation is completed, check and adjust the pedal travel as described previously. For the 1581-1747 -1929 D versions, take care when refitting the cable in the mountings on the gearbox or else the cable will deteriorate.

REMOVING-REFITTING HYDRAULICAL-LY OPERATED CLUTCH COMPONENTS (1998 20v)

CLUTCH PUMP

4. Remove the air intake duct acting on the bolts shown in the diagram.
   Disconnect the positive battery pole and remove the battery from the engine compartment working on the nut fixing the retaining bracket.