Workshop Manuals Factory service & repair Fiat
01 00 Introduction and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 33 Braking system06 41 Steering07 44 Suspension and wheels08 50 Auxiliary units09 55 Electrical system10 70 Bodywork
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)04 · 21 Gearbox and differential
04 · Transmission

Removing - refitting

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Removing-refitting (1370 12v) › Removing - refitting
21 Gearbox and differentialRemoving - refitting
Diagram showing electrical cables secured in clamps near the engine compartment
Diagram showing the battery and its mounting bracket within the battery cage

REMOVING - REFITTING

Removing

Place the car on ramps, remove the front wheels, then proceed as described below:

  1. Disconnect the battery's negative terminal, lift the protective cover from the positive terminal and disconnect the latter; undo the nut securing the battery mounting bracket to the battery cage and remove the battery.
  2. Release the electrical cables shown in the figure from their clamps, then undo the bolts securing the relay box cover.
  3. Remove the nuts securing the relay box to the battery cage, then move the box over to one side.
  4. Undo the bolts shown in the figure and remove the battery cage from the engine compartment.
Diagram showing the relay box and associated wiring harnesses
Diagram showing the bolts securing the battery cage to the vehicle frame

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.