Removing - refitting

Removing - refitting

21-27.

1. Manoeuvre the jack as appropriate to release the gearbox from the centring studs, then remove the gearbox from the engine compartment by slowly lowering the hydraulic jack.

Refitting

Before refitting the gearbox-differential unit, check that the clutch release bearing has remained in the bellhousing and has not engaged with the clutch. Carry out the operations below:

2. Check that the clutch release bearing is positioned correctly on the gearbox main shaft.
3. Secure the clutch release lever, in the fully back position, to the bellhousing, then using the hydraulic jack bring the gearbox-differential unit to the clutch, centre ot in its references and secure it to the engine. For the subsequent operations, reverse the procedure for removal.