Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)04 · 21 Gearbox and differential
04 · Transmission

Removing - refitting (page 2 of 4)

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Removing-refitting (1581 16v)
21 Gearbox and differentialRemoving - refitting · page 2 of 4
Illustrates drive shaft joint assembly with bolts and surrounding components
Diagram showing the gearbox area with bolts and a retaining button for wheelarch protection
Diagram showing a puller tool being used on a vertical link arm, labeled 1847038000
Diagram showing bolts securing a plastic component near suspension struts, with icons indicating lifting and lowering
Diagram showing a drive shaft being withdrawn from a wheel hub assembly
  1. Remove the plastic wheelarch protection on the gearbox by undoing the bolts and retaining button shown in the figure. To withdraw the protection, it is also necessary to disconnect the brake pad wear sensor connector (repeat the procedure on the other side).
  2. Remove the nut securing the steering tie-rod end, then withdraw the latter from the vertical link arm using the puller 1847038000 (repeat the procedure for the other tie-rod end).
  3. Remove the nuts securing the vertical link (gearbox and timing side) to the damper.
  4. Rotate the vertical link as appropriate so as to withdraw the drive shaft from the wheel hub (repeat the operation for the other drive shaft).

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.