Adjusting handbrake

Refit the dismantled parts in reverse order to removal, and then adjust the handbrake.

1.2. Detach the cables from the handbrake control by undoing the points illustrated.

3. Remove the protective cover illustrated and release the handbrake cable from the anchor on the lever, then withdraw the sheath with the handbrake cable and remove it.

Adjusting handbrake

The handbrake cables are connected to a bracket which acts directly on the automatic adjuster. Whenever repairs are carried out on the rear brake which involve dismantling the cables, the cables must be adjusted to ensure the correct operation of the automatic adjuster.

Proceed as follows:

• Undo the handbrake cable adjustment nut two or three turns, to make sure that the cable is fully slack.
• Start the car with the gear lever in neutral, and with the engine idling, depress the brake pedal fully at least 30 times.
• Retighten the cable adjustment nut previously unscrewed, making sure that the rear wheels turn freely when the handbrake lever is at rest.
• Check that the braking action starts from the first or second notch, and then at the end of adjustment the lever does not engage more than five notches on the sector gear.