Operation

Operation

The handbrake operates by means of a cable on the rear brakes.

At the bottom, this cable is attached to the bracket (1), the top of which is hinged onto the shoe (2) by the retaining washer (3) (this should be replaced whenever the rear brakes are overhauled).

The top of the bracket (1) is also connected to the automatic adjuster assembly for recovering the clearance caused by shoe wear, so the handbrake does not require adjustment. The bracket (1) homes on the shoe (2) via the lug (5).

Handbrake components

1. Handbrake lever complete with sector gear
2. Handbrake cable complete with anchorage
3. Sheath with cable
4. Mounting plate

NOTE Check the operation of each component and that the cable slides freely in its seating. If wear or tight spots are found, replace the parts concerned.