General warnings

GENERAL WARNINGS

IT IS ABSOLUTELY FORBIDDEN to use any type of seat cover that is not specifically designed for this type of seat. When replacing, take the greatest care to install in the correct position: the wording SIDE BAG must be on the same side of the squab as the side bag module.

Before disconnecting the seat connections to the air bag system (leads with yellow sheath), disconnect both battery terminals, take them out carefully and WAIT AT LEAST 10 MINUTES. Whenever working on the air bag system, it is OBLIGATORY to check system function using special test equipment at the end of the procedure.

It is STRICTLY NECESSARY to observe the contents of Identification and warning plates on the side bag module whenever the module is handled. When replacing the module, take off the removable label (1) on the cover of the new module and apply it to the front part of the seat structure at more or less the point indicated in the following figure so that it is legible with the seat fitted. Also record the serial number in the special log so the unit can be traced. If the seat structure is to be replaced and the side bag module transferred, the above label must be transferred from the old to the new structure.

1. New side bag module
2. Removable self-adhesive plate