Key Programming (page 3 of 3)

Place the MASTER key in the OFF position, extract it and return it, the key programming procedure is over.

If the procedure has been carried out correctly, i.e. as far as the timing and operations are concerned, if the ignition key is placed in the ON position, the CODE warning light will go out after coming on initially for 0.7 seconds, otherwise it will start to flash in rapidly (1.6 Hz); if this is the case, the programming procedure must be repeated.

If a mistake is made (at any time) during the programming procedure, place the ignition key in the ON position for longer than 2 seconds or in the OFF position for longer than 10 seconds, then start the key programming procedure again.