Replacing rear light cluster

Replacing rear light cluster

1. Remove the rear light cluster as described on page 26 - sec. 55 of the manual.
2. Make sure, before fitting the rear light cluster, that the frame fixing the light cluster to the bodyshell, is positioned at the centre of the seal pre-loading adjustment screws; if this is not the case, adjust the screws as shown in the diagram.
3. Correctly position the rear light cluster on the bodyshell and tighten the fixing bolts shown in the diagram.
4. Gradually tighten the bolts in the order shown, then continue the tightening until they actually break.

The operation described above allows the right pressure for the rear light cluster perimeter trim on the bodyshell.

NOTE Complete the fitting of the elements removed, reversing the order of the operations carried out for the removal of the rear light cluster.