Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)10 · 70 Bodywork
10 · Body & interior

Removing-refitting rear side panel

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Interior fittings › Removing-refitting rear side panel
70 BodyworkRemoving-refitting rear side panel
Diagram showing the rear seat cushion and its attachment points to the vehicle floor.
Diagram showing a person lifting the running board trim to access the bolt underneath.

REMOVING-REFITTING REAR SIDE PANEL

  1. Remove the seat cushion following the instructions given on the previous page, then remove the seat belt attachment bracket undoing the fixing bolts.
  2. Lift up the running board trim, then undo the bolt underneath.
  3. Undo the bolt fixing the rear seat belt and the bolts fixing the panel to the floor.
  4. Lower the seat backrest, then undo the bolts fixing the panel to the bodyshell.
  5. Gently remove the door seal, then using tool 1878077000 remove the rear side panel from the vehicle.

NOTE To refit simply reverse the order of the operations carried out for the removal.

Diagram showing the rear seat backrest lowered and the bolts fixing the side panel to the bodyshell.
Diagram showing the rear side panel being removed from the vehicle after undoing all fixings.
Diagram showing the use of tool 1878077000 to gently remove the door seal and rear side panel.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.