Removing

The roof panel trim (A) is now fastened round the edge as with the other versions and in the centre (as shown in cross section in figure 1) by means of two studs that screw into bolts (G) applied to beams (B) of the sun-roof assembly. Two vibration-damping foam washers (F) are fastened to the roof panel trim on the through holes used for the fastening studs.

Removing

Remove the various parts described in the previous pages, which are used to fasten the roof panel trim round then edge. Then un-screw studs (E, figure 2) retaining the trim to the sun-roof beam, taking care not to damage the trim. Lastly, remove the roof panel trim from the vehicle through the tail-gate compartment (see illustration on page 60).

Refitting

Postion the roof panel trim correctly inside the vehicle roof so that the two holes (arrowed in figure 3) coincide with bolts (G) applied to beams (B) of the sun-roof assembly. Fit studs (E) onto bolts (G) and then carry on fastening the roof trim by refitting the various parts described previously and carrying out the operations described on the previous pages in reverse order.

Detail of roof panel trim