Refitting

Refitting

1. Clean the roof panel thoroughly using disposable paper impregnated in heptane.
2. Apply the specified adhesive to the area shaded in the figure. Observe the dimensions shown.

NOTE It is advisable to use a water-based adhesive, e.g. TIVOCOLL 4769/59 manufactured by TIVOLI, or an equivalent GURIT or ESSEX product.

1. Heat the roof panel trim for about 5-6 minutes using an infra-red lamp and position the trim on the roof panel.

Do not allow the temperature to exceed 90°C, then fit the passenger grap handles and retaining studs. Press the trim so that it adheres to the roof, working from the centre outwards, then finish refitting by reversing removal instructions.