Rear bumper - central element

Operation 7210E67 · External parts

1.2 8v, 1.6 16v, 1.3 JTD 16V, 1.9 JTD 8V, 1.9 DIESEL

Removing

1. Undo the bolts (1a) and remove the bumper (1b)

If the bumper is body-coloured, take special care not to damage the paint.

Refitting

Check that the bumper is undamaged.

Touch up the paintwork if necessary.

Fit the bumper and secure it using the bolts.

1.4 8v, 1.6 16v, 1.3 JTD 16V, 1.9 JTD 8V · from 12/03 · MY 2005

Removing

Position the vehicle on a lift.

Turn the ignition key to the OFF position.

Lift the bonnet

Disconnect the negative battery terminal.

1. Unscrew the bolts in the lower part of the bumper from both sides.

1. Undo the bolts in the upper part of the bumper.

1. Disconnect electrical connections (1a) from the parking obstacle detection sensors, release the wiring from retaining collar (1b) and remove bumper (1c).

If the bumper is car-coloured, take care not to damage the paintwork.

Refitting

Check that the bumper is not damaged.

If necessary, retouch the paintwork.

Connect the electrical connections to the parking obstacle detection sensors.

Secure the parking sensor system wiring to the retaining collar.

Position the bumper in its seat and secure with the bolts.

Connect the negative battery terminal.