Steering control shaft SUPPORT - R.R.
- Make
- Fiat
- Model
- Doblò Factory Service Manual
- Year
- 2000–2010
- Section
- Steering control and linkage › Steering control shaft SUPPORT - R.R.
Steering control shaft SUPPORT - R.R.
Removing
Disconnect the battery negative terminal.
Op. 4110A10 STEERING WHEEL - R+R FOR REPLACEMENT OR CHECKS.
Op. 7040A26 STEERING COLUMN TRIM - R+R.
Op. 5550A10 STALK UNIT ASSEMBLY - R+R.
1. Undo the fixing bolt (1a) and disconnect the universal joint (1b) for the steering column.
1. Remove the aerial from the ignition switch.
1. Disconnect the electrical connectors for the ignition switch and place the wiring to one side.
| Name | Connector | |
|---|---|---|
| 1 | Ignition switch | See H001 IGNITION SWITCH |
1. Undo the fixing nuts and remove the steering shafts support.
Refitting
Position the steering shafts support and tighten the fixing nuts to torque.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| Nut | STEERING SHAFT MOUNTING | M8 | (On bodyshell) 2.8 |
Fit the aerial on the ignition switch.
Connect the electrical connectors for the ignition switch.
| Name | Connector | |
|---|---|---|
| Ignition switch | See H001 IGNITION SWITCH |
Connect the universal joint for the steering column and tighten the fixing bolt to torque.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| Bolt | STEERING SHAFTS | M8 | 3.7 |
Op. 5550A10 STALK UNIT ASSEMBLY - R+R.
Op. 7040A26 STEERING COLUMN TRIM - R+R.
Op. 4110A10 STEERING WHEEL - R+R FOR REPLACEMENT OR CHECKS.
Connect the battery negative terminal.
Parts & tools for this job For 2000 Fiat Doblò
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Fiat power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.