2.2. Refitting

Remove the cable from under the vehicle, taking care not to cut off the thread during the operation. As soon as the cable is entirely disengaged from the bodyshell, detach the thread from the yoke.

2.2. Refitting

CAUTION : Adhere to the tightening torques [info icon].

N.B. : Use the thin thread, utilised during the removal, to put the new cable into place more easily.

1. Secure the free extremity of the thread to the cable yoke.
2. Pull the thread moderately, seeing to it that the cable engages easily.
3. Fit the nuts (7).
4. Engage : The sheath in the retaining base (5).
5. Couple the brake cable on the yoke (6).
6. Refit the nut (3).
7. Engage the cable in the handbrake lever.

Refit :

• The shaft (4)
• The washer (1)
• Locking clip (2)
• The handbrake control lever trim

3. Handbrake secondary cables

3.1. Removing

Unscrew the rear wheels.

Raise the vehicle and support on axle stands, wheels free.

Remove :

• The rear wheels
• The rear brake discs
• The rear hub bearings
• The parking brake shoes (on each side)