3. Refitting (page 2 of 3)

• The engine mounting (24)
• The bolts (32), (25), (30)
• The nuts (23), (31), (28)

Unclamp the power unit assembly from the lifting table [0004].
Withdraw the lifting bench [0004] from under the vehicle.
Remove the tools [0005-C], [0005-G].

Refit :

• The reaction link (18)
• The (22) bolt
• The bracket (20) (Reaction rod (18))
• The bolts (19)
• The bolt (21)

Refit :

• The air-conditioning compressor (According to equipment)
• The power steering pump

Position and couple up :

• The gear control and selection cables
• The starter electrical supply (at "c")
• The hydraulic clutch control (17)

Reconnect the electrical harnesses (16).
Position : The fuse box (at "b").
Refit : The cover of the fuse holder unit.

Refit : The heater matrix inlet and outlet hoses (14), (15).
Reconnect the air flowmeter (at "a").
Remove the tool [0188-T] (Brake servo pipe (8)).

Refit :

• The radiator top hose (13)
• The expansion bottle pipe (12)
• The air duct (7)
• The air filter housing (11)
• The cover (10)
• The clips (Electrical harness (9))
• The braking assistance pipe (8)

Couple up : The fuel supply and return pipes (5), (6).
Refit : The air take-off (4).
Position : The scuttle (3).
Remove the tools [0188-T] (Fuel supply and return pipes (5), (6)).

Couple up :

• The turbocharger air outlet pipe (2)
• The turbocharging air cooler air outlet hose (1))

Refit :

• The pre-catalytic converter
• The drive shafts
• The front wheels
• The right-hand headlamp
• The central section of the lower front panel
• The protection plates under the engine