1. Preliminary operations

ESSENTIAL : Observe the safety and cleanliness recommendations.

1. Preliminary operations

Remove the air filter and air inlet duct assembly.

CAUTION : Mark the level of brake fluid in the reservoir before carrying out the operation.

Remove the brake fluid reservoir cap.

1.1. Assembly with hydraulic clutch control slave cylinder

Figure : B2BI00JD

CAUTION : The end of the transparent pipe must be submerged into the brake fluid.

Bleed the hydraulic clutch control circuit :

• Couple a transparent pipe onto the bleed valve (1)
• Plunge the end of the transparent pipe into a receptacle containing brake fluid, placed lower down than the hydraulic clutch control slave cylinder
• Press the locking clip (2)
• Pull the clip (3) by one notch in the direction of the arrow (open position)

1.2. Fitting with hydraulic stop