4. Refitting (page 5 of 5)

Figure : B2BG08JD Gradually compress the clutch mechanism (2) until it touches the primary flywheel (at "f"). Check that there is no friction:

• Apply light pressure to the clutch disc (3) to check that it turns, using a thin, flat screwdriver
• If it turns with difficulty or not at all, continue compressing the clutch mechanism very gradually until it turns (1/8 turn at a time on the bolt of tool [0217-B2Z])

If it is not possible to check for friction (clutch disc not accessible), screw in the centre bolt of tool [0217-B2Z] by no more than two further turns. Tighten the 3 bolts (1) to the specified torque. Unscrew the centre bolt of the tool [0217-A] (at "a") by several turns to detension the clutch mechanism (2). Remove tools [0217-A], [0217-B2Z] and [0217-CX]. Refit and tighten the remaining 3 bolts (1). Refit the gearbox.