4. Refitting

Fit the clutch disc (3) on the splined shaft and slide it back and forth several times to spread the grease. Remove the clutch disc.

Figure : B2BG08GD

CAUTION : An excess of grease will contaminates the clutch friction plate and cause noise in neutral, slipping or juddering of the clutch.

"d" : Grease marks on a clutch disc contaminated by too much grease.

"e" : Grease marks on a clutch housing contaminated by too much grease.

CAUTION : Clean off any grease that could be thrown onto the friction lining as it turns.

Remove the surplus grease on the top of the grooves and the end of the input shaft using a cloth.

N.B. : The film of grease on the rotating parts must be as thin as possible so that none is thrown off.

4. Refitting

CAUTION : Observe the tightening torque values.