3.2. Greasing

If there is oil in the clutch mechanism (2) :

• Check the condition of the crankshaft oil seal
• Check the condition of the input shaft oil seal

CAUTION : Do not reuse a clutch disc whose hub shows traces of oxidation or grease.

Remove the oxidation from and degrease the following parts, using a degreaser Index "N1" :

• The clutch housing
• The primary shaft
• The clutch bearing guide (according to equipment)
• The clutch fork (according to equipment)

N.B. : If there is heavy corrosion, use a wire brush without damaging the parts.

3.2. Greasing

CAUTION : Follow the greasing step exactly.

Figure : B2BG08FD

CAUTION : Protect the interior of the clutch housing from splashes of grease.

Vehicles equipped with a gearbox that has a mechanical clutch bearing Spray a little grease MOLYCOTE G-RAPID PLUS (aerosol) on the splines of the primary shaft and on the clutch bearing guide tube (at "b" and "c"). Vehicles equipped with a gearbox that has a hydraulic clutch bearing : Grease the splines of the primary shaft with MOLYCOTE G-RAPID PLUS (at "c").

CAUTION : Do not contaminate the clutch disc lining; risk of clutch slip.