3. Preparation for removal

Figure : B2BG08ED

Remove the 3 bolts (1) (Every second bolt).

Position the tools [0217-A] and [0217-B2Z] on the clutch mechanism (2).

CAUTION : Some flywheels have through-tapped holes. Do not let the threads of the 3 retaining rods protrude when screwing them in; risk of distorting the secondary flywheel.

Screw in the 3 retaining rods [0217-B2Z] in place of the fixing screws (1); do not let the threads protrude.

CAUTION : When compressing the clutch mechanism, do not force past a hard point when tightening the centre bolt of tool [0217-A]. Do not tighten by more than 10 turns clockwise.

Compress the clutch mechanism (2) with the central bolt of tool [0217-A] (at "a").

Finish removing the remaining bolts (1).

Release the clutch mechanism (2) by moving the central bolt of the tool [0217-A] (at "a").

Remove tools [0217-A] and [0217-B2Z].

Remove :

• The clutch mechanism (2)
• The clutch disc

3. Preparation for removal

3.1. Checking - Cleaning

Visually check :

• The flywheel face for damage or scores
• The flywheel for wear
• The condition of the starter ring gear
• The clutch mechanism (2)