3. Refitting

Figure : B3DP0DJD

Remove the rear suspension.

Handle the rear suspension; Using tool [1].

Equip tool [2] plate with its detachable legs, so as to liberate tool [1].

3. Refitting

CAUTION : Always fit new Nylstop nuts.

Place the rear axle under the vehicle; Using tool [1].

Refit :

• The rear axle
• The bolts (7), (8)

Refit dampers upper fixing (5).

ESSENTIAL : Before carrying out the final tightening of fixings (5), (6), (7), (8), the vehicle MUST be placed at the load setting height.

Remove the tools [1], [2].

Refit (on each side) :

• The brake caliper (2)
• The bolt (1) (new) Pre-coated with a thread-locking product

Tighten the bolt (1) to 3 ± 0,3 daN.m.

Fit the brake pads (see the relevant operation).

Couple the handbrake cables at the compensator (4).

Fit the handbrake sleeves in their housing (at "c", "d").

Adjust The handbrake cables (see the relevant operations).