4.2. Driveshaft GKN

Fill the gaiter with all the grease available in the repair kit.

Refit the gaiter (5) on the housing (3).

CAUTION : Pay attention to the location of the gaiter on the shaft: gaiter lip in the groove "a" or on the mark made when removing.

Refit and tighten the clips (1) and (2).

4.2. Driveshaft GKN

N.B. : The driveshaft bowl on the wheel side cannot be removed; The replacing of a wheel-end driveshaft gaiter necessitates the removal of the gearbox-end gaiter.

Figure : B2FH00QD

Remove :

• The drive shaft gaiter (on the gearbox side)
• The clips (7), (8)
• The drive shaft gaiter (9)

Refit the driveshaft gaiter (9) on the driveshaft.

Fill the gaiter with all the grease available in the repair kit.

Refit :

• The collars (7) and (8)
• The drive shaft gaiter (on the gearbox side)

5. Replacement : Gearbox end gaiter

CAUTION : Always replace the clips and circlips that have been removed.