5.2. Driveshaft PSA

Remove the driveshaft gaiter (11).
Refit the driveshaft gaiter (11) on the driveshaft (new).
Refit :

• The tripod (15)
• The circlip (14)

Fill the gaiter with all the grease available in the repair kit.

Refit :

• The tripod housing (12)
• The collars (10) and (13)

5.2. Driveshaft PSA

N.B. : At the gearbox end, as the spider cannot be removed, replacement of the gaiter is only possible following removal of the seal at the wheel end.

Figure : B2FH011D

Remove :

• The drive shaft gaiter (11) (road wheel side)
• The clips (10), (13)
• The tripod housing (12)
• The drive shaft gaiter (11)

Take as much grease as possible off the driveshaft seal; Do not use solvents.
Fit the new gaiter (11) on the drive shaft.
Spread the grease between the gaiter and the tripod.
Refit :

• The tripod housing (12)
• The clips (10), (13)