Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Multipla Factory Service Manual (1998-2010)17 · Body fittings
17 · Body & interior

Rear BUMPER - R.R.

Make
Fiat
Model
Multipla Factory Service Manual
Year
1998–2010
Section
Mouldings on protections › Rear BUMPER - R.R.
Body fittingsRear BUMPER - R.R.

Rear BUMPER - R.R.

Operation 7055B18 · EXTERIOR PROTECTIONS

Removing

- 7055B43 REAR WHEEL ARCH liner (one), left or right - R.R. (right and left)

1. Working from both sides of the car, undo the bumper's side bolts.

Rear BUMPER - R.R.

1. Open the tailgate and undo the top and bottom bolts.

2. Remove the bumper.

1. If necessary, undo the bolts securing the buffers.

2. Remove the buffers.

Rear BUMPER - R.R.

Refitting

If removed, fit the buffers and tighten their bolts.

Check that the bumper is undamaged.

Fit the front bumper.

Tighten the bumper's top and bottom bolts.

Tighten the bumper's side bolts.

- 7055B43 REAR WHEEL ARCH liner (one), left or right - R.R. (right and left)

Parts & tools for this job For 1998 Fiat Multipla

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.