Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Multipla Factory Service Manual (1998-2010)17 · Body fittings
17 · Body & interior

Windscreen base TRIM - R.R.

Make
Fiat
Model
Multipla Factory Service Manual
Year
1998–2010
Section
Mouldings on protections › Windscreen base TRIM - R.R.
Body fittingsWindscreen base TRIM - R.R.

Windscreen base TRIM - R.R.

Operation 7055A18 · EXTERIOR MOULDINGS

04/02 to 08/03, 06/99 to 03/02, from 09/03, up to 05/04, up to 05/99

Removing

- 5050B32 windscreen wiper arm/s - r+r (right and left)

1. Remove the air filter cover.

2. Undo the bolts.

3. Disconnect the windscreen washer jet pipes and save the trim.

Windscreen base TRIM - R.R.

Refitting

Check that the trim is undamaged.

Connect the pipes to the windscreen washer jets.

Tighten the screws.

Fit the air filter cover.

Check that the windscreen washer jets are working.

- 5050B32 windscreen wiper arm/s - r+r (right and left)

Check the operation of the windscreen wiper.

Parts & tools for this job For 1998 Fiat Multipla

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.