Workshop Manuals Factory service & repair Fiat
01 00 Introduction and technical data02 10 Engine03 21 Gearbox and differential04 33 Braking system05 41 Steering06 44 Suspension and wheels07 27 Axle and rear differential (4x4)08 24 Propeller shaft (4x4)09 55 Electrical system10 70 Bodywork
Fiat Panda (141) Factory Service Manual (1986-2003)03 · 21 Gearbox and differential
03 · Transmission

Order of operations

Make
Fiat
Model
Panda (141) Factory Service Manual
Year
1986–2003
Section
Removing-refitting › Order of operations
21 Gearbox and differentialOrder of operations · page 1 of 4

ORDER OF OPERATIONS

Position the vehicle on the lift in such a way that it is possible to remove the gearbox-differential unit from the lower section of the engine compartment, then:

Proceed as follows:

  • Remove the items illustrated below:
Diagram showing removal points for various components including cables, linkages, and brackets around the engine and gearbox area.
  • Also remove the starter motor from the bell housing and position it in the engine compartment

– Position cross member 1870595000 to support the engine
– remove the gearbox-differential, gearbox side support bracket
– remove the front left wheel.

Raise the vehicle and carry out the following operations from below:

  • drain the gearbox oil using spanner 1850113000
View from underneath the vehicle showing the engine and gearbox supported by a cross member bar spanning across the chassis.

Parts & tools for this job For 1986 Fiat Panda

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.